Wear and Friction Resistant M8 Lifter Cuffs
These Feuling Parts M8 lifter cuffs are injection molded glass-filled nylon with added Teflon to increase wear and friction resistance.
Stronger than factory replacements and with added friction reducer, they have been developed by Feuling as an upgraded alternate to the conventional billet replacements that are often found to cause debris and harmonics due to rubbing on the steel lifter flats.
Billet cuffs allow excessive lifter rotation /rocking which can lead to axle/roller failure as the lifter is naturally trying to roll off the camshaft lobe. It only takes a few degrees of rotation for the lifter roller to stop spinning.
Features include increased clearances for larger lift cam shafts, and they are able to use with up to the Feuling 618 camshaft without modification. The factory only allows for up to ~0.540 lift.
They are recommended to be used with Feuling lifters as they fit the tight tolerances, however other branded lifters are compatible. Lifters should have a light slip to snug fit in the cuff. ARP fasteners and wedge lock washers included. They are made in USA.
FEULING PARTS
