Available exclusively through Drag Specialties, these fenders by Murietta, California based manufacturer Russ Wernimont Designs (RWD) and made from heavy-gauge steel, with each fender inspected individually to ensure straightness, consistency and a “flawless finish with an absolute minimum of finishing bodywork.” Each fender is pre-drilled for easy bolt-on installation.
 |
| Custom dresser fender |
Also seen here, the ready-to-paint RWD Flat Back Front Dresser Fender has been laser trimmed to complement the rake of the bike. A direct bolt-on design, no spacers are required.
 |
| Flat back dresser front fender |
The RWD 8.5” OEM-style Dyna rear fender is a one-piece, stamped 14-gauge construction, laser-trimmed for a precise fit with minimal paint prep. Welded wire tube for clean wire installation, the fender mount and license plate bracket holes are predrilled and also has taillight cutout for traditional taillight mounting.
 |
| 8.5” OEM style Dyna Fender |
This RWD highway bar/skid plate design with footrests is made in 1 3/4” steel tubing and stamped 14-gauge steel plate with a gloss black powder coat finish.
 |
| Highway bar/skid plate with foot rests |
Measuring approximately 34” wide x 12” tall, it has high impact plastic “Revolver” end caps that double as footrests. It ships with all necessary mounting hardware (not for use with evaporative emissions canister or Big Bear motor mounts).
DRAG SPECIALTIES
www.dragspecialties.com
www.russwernimont.com
